StickerYou Blog

How to Remove Stickers From Golf Clubs

February 26, 2024  |  
Golf club with branded stickers stuck on the clubhead

So you just got a new club and you can’t wait to take it for a round of golf. But there’s something you don’t quite like about your investment — the stickers covering the perfectly good shaft or clubhead. Most golfers don’t like these manufacturer-placed stickers, and many of them take the time to remove them.

The good news is removing stickers from golf clubs is easy to do, as long as you know the best ways to go about it. 

Best Methods to Remove Stickers From Golf Clubs

With the right tools and materials, you can remove stickers from your brand-new golf club without damaging it. Here are the best methods that golfers swear by:

Vegetable Oil

Vegetable oil, or any cooking oil, for that matter, is quite effective in loosening up sticker adhesive. Allow it to soak the sticker for a couple of hours and you’ll find the sticker easy to peel off with a plastic scraper. You can then tackle adhesive residue with a soft towel. 

Hair Dryer/ Heat Gun

Heat is great at helping even the strongest adhesive loosen its hold on surfaces. For this method, you can use a heat gun or hairdryer set to low heat. Point your heating device a couple of inches away from the sticker and turn it on. When the sticker has warmed up, it should be easy to peel off with a plastic scraper. 

Goo Gone/WD-40

Goo Gone is a commercial solvent that’s made specifically for removing stickers from a range of surfaces. It’s safe to use on golf clubs, but if you want to be a bit more careful with your new investment, then you might be more comfortable with good ol’ WD-40. 

Regardless of which of the two you opt for, these solutions will be able to help remove the sticker within a few minutes.

A white golf club and a golf ball left on the grass of a golf course.

How to Remove Stickers From Golf Clubs: Step by Step

Now that you know the best methods to remove eco-friendly stickers from golf clubs, you can get started with the sticker removal process using your preferred strategy. In case you need a little bit more guidance, we provide you with a step-by-step guide below. 

Step 1: Peel Off as Much as Possible

First, peel off as much of the sticker as you can with your fingers. Don’t worry if you can’t get all of it off! The goal here is to make the sticker thinner to allow the next steps to work better. 

Step 2: Heat Application

Take a heat gun or hair dryer and set it to its lowest heat setting. Hold the device a few inches away from the sticker and begin to apply heat. If you are working with a large sticker, make sure to cover all bases, moving the device back and forth on the entire surface. 

Step 3: Peeling with Plastic Tool

When the sticker gets warm, get a plastic scraper or an old credit card and use it to lift a corner of the sticker. Slide the plastic tool under the lifted corner and begin to scrape gently. If you encounter any resistance, you can go over the area with your heating device again. 

Step 4: Adhesive Removal

After peeling the sticker off, you may notice some leftover adhesive residue on your golf club’s shaft. You can remove this by soaking it in cooking oil, WD-40, or Goo Gone adhesive remover. Leave the solution to sit on the surface for a few minutes before gently scrubbing the residue with a paper towel or cloth. 

Step 5: Cleaning and Drying

When the adhesive residue is gone, clean your golf club with water and mild soap, focusing on the area where the sticker used to be. Wipe the surface dry with a clean towel. 

Step 6: Polishing (Optional)

This step is optional, but if you want to restore your golf club’s shine after the sticker removal process, you can opt to apply chrome or steel polish made specifically for golf clubs with a soft towel. 

Protective Coating

To ensure your golf club lasts you years to come without the risk of rust and corrosion, you can apply a protective coating finish. Just pour a small amount on a soft microfiber cloth and gently spread the coating on the shaft. 


You don’t have to worry about looking at that manufacturer-placed sticker you hate so much every time you play a round of tee with your buddies. With our sticker removal methods above, you should be able to easily and safely remove stickers from golf clubs without causing any irreparable damage. 

Are you also looking to replace the manufacturer-placed stickers with more interesting ones? If so, please have a look at our collection of top quality funny stickers and creative meme stickers for further inspiration!

How to Remove Stickers From Golf Clubs: FAQs

Can you use Goo Gone on golf clubs?

Goo Gone is a powerful adhesive remover that can tackle sticker adhesive residue on virtually any surface. It’s safe to use on golf clubs. When using Goo Gone, soak the area with the solution and let it sit for a couple of minutes before wiping the residue off with a paper towel. 

Can you use alcohol to clean golf clubs?

You can use alcohol to clean your golf clubs. It won’t damage the finish and doesn’t leave behind any residue because it evaporates quickly. It’s best practice, however, to dilute the alcohol with water before proceeding. 

How do you get stickers off golf irons?

To remove stickers off an iron shaft, apply heat onto the surface for a few minutes. When the sticker has warmed up, peel it off using a plastic scraper or an old credit card. Tackle adhesive residue with cooking oil, WD-40, or Goo Gone adhesive remover.